How to set up a proxy in Microsoft Edge
Microsoft Edge uses the Windows system network settings, so the setup follows the same operating system proxy panel plus a final route verification step.
On this guide page
What this guide covers Step-by-step flow What to verify after setup What to do nextGuide page status
Other setup guides
Microsoft Edge uses the Windows system network settings, so the setup follows the same operating system proxy panel plus a final route verification step.
What this guide covers
Proxy setup in Microsoft Edge: how to open the Windows proxy settings, apply the IP and port, and verify the new outgoing route.
Step-by-step flow
Open the system proxy panel
From Edge, jump to the Windows network settings where manual proxy configuration is available.
Use a fresh address
Copy the current IP and port from the country page or the dashboard so the route is not reused blindly.
Enable manual proxy mode
In Windows, switch on manual proxy setup and fill in the server and port fields.
Restart active browser tabs
After saving, refresh the important tabs or restart Edge so old connections are dropped.
Verify the result
Confirm the new IP on the IP info page and, if needed, inspect headers and blacklist reputation afterwards.
What to verify after setup
- Edge is a good fit when a system-wide proxy route is needed without separate browser-specific configuration.
- If the route does not change, verify that the application is not holding old network connections open.
- After enabling the proxy, both judge checks and DNSBL checks help validate the route quickly.
Use this page as a working checklist: apply the route, then immediately verify the visible IP, judge headers, and the real workflow.